HVAC Services in Los Angeles County

AIRPRO SOLUTIONS provides HVAC services in Los Angeles County - from coastal Santa Monica and Long Beach to Burbank, Glendale, and Pasadena - with equipment, permits, and rebates matched to each city.

  • Licensed
  • 4.8-star rated
  • Residential & commercial
  • Eight cities covered
Map showing the Los Angeles County service areaLos Angeles County, CA 8 cities served
8 citiescovered on this page
4.8★average rating, 40 reviews
LicensedCA LIC #1126691, #50251
Coast to foothillsone region, several climates

Quick answer

AIRPRO SOLUTIONS is a licensed HVAC contractor serving Los Angeles County, including Los Angeles, Long Beach, Pasadena, Glendale, Burbank, Culver City, Santa Monica, and Inglewood, for homes, multifamily buildings, and commercial properties. Sizing, permits, and rebates change by city and sometimes by address, so every recommendation starts with the property, not a county-wide assumption.

Local knowledge

One county, several climates: what that means for your system

The California Energy Commission describes the Los Angeles region as a Mediterranean climate with hot, dry summers and cool, wet winters. Within the county, the ocean buffers the coast while inland areas run hotter, so a system that suits Santa Monica is not automatically the right one for Burbank.

LAX, a coastal reference station rather than a city reading, historically records fewer than 15 days a year at or above 90°F, and low marine clouds make up more than 80 percent of coastal clouds from June through September. Inland valleys and foothill areas see the largest extreme-heat changes in the region. Winters are cool and wet, so there is a real heating season, and Santa Ana winds bring very dry offshore air from October through April.

That is why we size equipment from a load calculation for your specific property rather than a county-wide temperature assumption. Hotter outdoor conditions mean a system runs more often or longer to hold the same indoor setpoint, which is why the address matters.

Where each city sits

Santa MonicaLong Beach
Culver CityInglewood
Burbank
GlendalePasadena
Los Angeles
Source: California Energy Commission, Los Angeles Region report (2018). City placement is general, not a climate-zone boundary.

Property types

Housing mix by city: from detached homes to apartment buildings

CitySingle-familyMultifamilyLargest single category
Los Angeles43.5%55.8%5-or-more-unit multifamily, 47.0%
Long Beach47.7%51.0%Single-family detached, 42.0%
Glendale39.0%60.9%5-or-more-unit multifamily, 52.3%
Burbank48.7%51.0%Single-family detached, 44.4%
Culver City48.4%50.4%Single-family detached, 39.4%
Santa Monica22.1%77.5%5-or-more-unit multifamily, 67.4%
Inglewood44.2%55.3%5-or-more-unit multifamily, 41.0%

Share of housing units by structure type, from SCAG local profiles using California Department of Finance E-5 data for 2018. Figures measure structure type only, not condo ownership, HOA status, or renter status.

Structure type shapes the job. Detached homes, townhomes, and apartments differ in access, equipment location, shared roofs and common areas, and permitting. Culver City is nearly evenly split between single-family and multifamily units, while Santa Monica is the most multifamily city here.

In the City of Los Angeles, HVAC equipment may not raise noise at an adjoining unit in a condominium, apartment house, duplex, or attached business by more than 5 decibels over ambient (LAMC 112.02), so placement and commissioning matter in attached buildings.

Older housing is common across Southern California. More than half of housing units in the six-county SCAG region were built before 1980. Age alone does not tell us whether a home has attic access, a slab or raised foundation, or original ductwork, so we confirm those at a site visit before recommending repair or replacement.

Residential and commercial

Homes, multifamily buildings, and commercial properties

Residential

Homes and multifamily

Sized to the property, with access, equipment placement, and building-management approvals checked first.

  • Detached homes
  • Townhomes and attached homes
  • Apartments and condos
Residential HVAC

Commercial

Commercial properties

The City of Los Angeles identifies Downtown, Century City, Warner Center, and the LAX area as primary employment centers.

  • Offices
  • Retail and restaurants
  • Rooftop units
Commercial HVAC

Permits and code

Each city runs its own HVAC permit process

Most HVAC replacements, new installations, relocations, duct changes, and gas or electrical changes require permits and inspections. We verify the applicable local permit path before work begins.

CityPermit officeWhat is different locally
Los AngelesLos Angeles Department of Building and Safety (LADBS)Same-size and same-type AC replacement is listed as an express permit category. It is a faster path, not a permit exemption. The City’s prior all-electric building ordinance was repealed effective October 13, 2025.
Long BeachDevelopment Services, Building and Safety BureauA separate permit is required for equipment in each separate building. HVAC permit submissions include a CF1R Title 24 compliance document.
PasadenaPlanning and Community Development, Permit CenterThe Permit Center at 175 North Garfield Ave. lists installing or replacing heating and cooling units among its plan and submittal items. The City’s site-plan requirement can apply to equipment placed outside, and building permits are valid for 180 days from issuance.
GlendaleBuilding & Safety DivisionA C-20 contractor or an owner-builder may apply for a single-family mechanical permit, and owner-builders may not apply for a multifamily one. The City also has an AC to Heat Pump reach code for replacements.
BurbankCommunity Development, Building and Safety DivisionRooftop or rear-of-property unit replacement, and replacement with new ducts or a new HVAC system, are scopes the City lists as needing an energy report.
Culver CityBuilding Safety DivisionEach structure and each permit type (building, mechanical, electrical, plumbing) needs its own application, so a heat pump change-out can involve more than the mechanical permit.
Santa MonicaCity plan reviewThe City sorts work into Same-Day Review for certain minor projects, including mechanical installations, and Plan Review for larger work. A permit is still required, and outdoor equipment is subject to the City’s equipment noise rules.
InglewoodBuilding Safety DivisionIssues building, electrical, plumbing, sewer, mechanical, and grading permits, and the City runs an online permit portal.

Title 24 applies statewide. California’s energy code is administered through each city’s building department. Many HVAC alterations need compliance documentation and third-party field verification and diagnostic testing, and duct leakage testing can apply when components are installed in ducted systems. The required tests are identified on the compliance forms for each job.

Unincorporated addresses follow County rules. If your property is in unincorporated Los Angeles County rather than one of these cities, County permit and noise rules apply instead, so we confirm jurisdiction before quoting.

Utilities and rebates

Your electric utility decides which rebates to look at

AIRPRO SOLUTIONS works across several electric utilities, and each publishes its own programs.

Up to $2,500 per ton

LADWP heat pump HVAC rebate for equipment purchased and installed on or after November 1, 2025. Equipment must be installed before applying, and funds are limited.

LADWP program page →

Furnace rebate

SoCalGas lists ENERGY STAR furnace rebates for qualifying existing homes during its 2026 program period. Funding is first-come, first-served and may end early. Check the program page for current terms.

SoCalGas program page →

Heat pump rebate

Burbank Water and Power lists a heat pump HVAC rebate for replacing gas equipment. New construction does not qualify, and funding is first-come, first-served and not guaranteed. Check the program page for current terms.

Burbank program page →

Region-wide programs. The CPUC Energy Savings Assistance Program offers no-cost weatherization to income-qualified SCE and SoCalGas households.

Long Beach and Santa Monica are served by SCE, and SCE publishes its current rebate offerings on its rebate center. Inglewood, Culver City, and Glendale: confirm current electric-utility incentives by address before relying on any rebate.

Rebates and eligibility vary by service address, utility account, equipment efficiency, income qualifications, and available funding. We can help identify potential programs, but confirm final eligibility, amount, and application requirements with your utility before installation.

Electric utility by city

Los Angeles: LADWPPasadena: Pasadena Water and PowerBurbank: Burbank Water and PowerGlendale: Glendale Water & PowerLong Beach: SCEInglewood: confirm by addressCulver City: confirm by addressSanta Monica: SCE
Natural gas: SoCalGas serves the region, subject to address confirmation.

Why AIRPRO SOLUTIONS

Recommendations that start with your address

Climate, building type, electric utility, and city permit rules all change across Los Angeles County. We check them for your property before recommending equipment, so the plan fits where you actually live or work.

4.8★Google rating
40Google reviews
8Cities on this page
LicensedCA LIC #1126691, #50251

Direct answers

Los Angeles County HVAC questions, answered

Which cities does AIRPRO SOLUTIONS serve in Los Angeles County?

This page covers Los Angeles, Long Beach, Pasadena, Glendale, Burbank, Culver City, Santa Monica, and Inglewood. South Bay cities such as Torrance are covered separately. If your address is in unincorporated county territory, call us first, because permit and code rules differ there.

Does HVAC sizing change between the coast and inland Los Angeles County?

Yes, the conditions do. The coast is buffered by the ocean and summer marine low clouds, while inland valley and foothill areas run hotter. Equipment should be sized from a load calculation for your property, not from a county-wide temperature assumption.

Do I need a permit to replace my AC in Los Angeles County?

In all eight cities on this page, replacing HVAC equipment generally requires a mechanical permit. Requirements vary by address, equipment type, ductwork scope, and any electrical or gas work. The City of Los Angeles lists same-size and same-type AC replacement as an express permit category, which is a faster path and not a permit exemption. We verify the applicable local permit path before work begins.

What is Title 24 and how does it affect an HVAC replacement?

Title 24 is California’s building energy code. Many HVAC replacements need compliance documentation and third-party field verification and diagnostic testing, and duct leakage testing can apply when components are installed in ducted systems. The exact tests depend on the project and are listed on the compliance forms for the job.

Which utility serves my home, and are there HVAC rebates?

It depends on the city and sometimes the address. Los Angeles is served by LADWP, Pasadena by Pasadena Water and Power, Burbank by Burbank Water and Power, Glendale by Glendale Water & Power, and Long Beach and Santa Monica by SCE. Inglewood, Culver City, and Glendale should be confirmed by address. SoCalGas is the natural-gas utility across most of the region, but Long Beach has its own municipal gas utility, Long Beach Utilities. Rebate amounts and funding change, so confirm current eligibility with your utility before installation.

Are there placement rules for outdoor equipment?

Sometimes. In Pasadena, the City’s site-plan requirement can apply to equipment placed outside. Other cities on this page have their own zoning and placement rules, so we check the property before recommending where equipment goes.

Do older homes in Los Angeles County need different HVAC work?

Older housing is common across Southern California. More than half of housing units in the six-county SCAG region were built before 1980. A home’s age does not tell us whether it has attic access, what kind of foundation it has, or whether the ducts are original, so we confirm those at a site visit before recommending repair or replacement.

Does AIRPRO SOLUTIONS handle commercial HVAC in Los Angeles County?

Yes, for offices, retail, restaurants, and other commercial properties. LADWP’s BOSS program offers incentives to eligible non-residential customers, and it requires LADWP pre-approval before installation. Call us before you buy equipment so we can check what applies to your building.

How quickly can a technician reach me?

Travel time across the county depends on traffic and freeway conditions. Dispatch timing is confirmed when service is scheduled, based on your location and technician availability.

Get HVAC service anywhere in Los Angeles County

Tell us your address and we will confirm the utility, permit path, and equipment options that apply.